How To Make A Three-Bottle Wine Rack

Ever thought about giving your wine collection a stylish new home? Well, that's exactly what I did with this DIY 3-bottle wine rack. I whipped it up using 2x6s, which definitely had its challenges. I mean, they're not exactly the most glamorous of materials, are they? But with a little creativity and elbow grease, I was able to turn them into something pretty chic.

This is a great project if you want to have a new home for your wine bottles, whether it’s on your bar or maybe hanging on the wall. So grab your tools and let’s get started!

Cut List

Solid Wood	Qty	Dimensions (Inch)	Thickness
Top/Bottom	2	15 x 5-1/2	1-1/2
Side	2	23 x 5-1/2	1-1/2
Dowel Rod	6	16-1/2 x D=1/2

Materials

Item	Qty	Specification
Wood glue	1
Wood stain	1
Wood varnish	1	polyurethane
Sandpaper	4	80, 150, 220, and 320 grit
Keyhole hander	2
Pocket Hole Screws	1 pac	2-1/2"

Tools

• Circular Saw
• Drill
• Clamps
• Sander
• Pocket Hole Jig
• Router with ⅛” bit round over
• Optional - keyhole hanger jig
• Flush cut saw

Process

Step 1

Cut out all the necessary wood pieces for the wine rack. Then, sand each piece with 80 and 150-grit sandpaper to ensure a smooth finish.

Step 2

On the Sides, mark and drill holes for the dowels with a diameter of 1/2 inch and a depth of 3/4 inch. Additionally, drill pocket holes for assembly.

Step 3

Apply glue to the ends of the dowels, then insert them into the holes in both Sides.

Step 4

Join the Top and Bottom pieces to the Sides, securing them with clamps. Attach the Sides to the Top and Bottom using pocket hole screws. Round the edges using a Router with a 1/8 inch bit.

Step 5

Fill the pocket holes with glue and dowels. Trim off any excess dowels using a Flush Cut Saw.

Step 6

Sand the entire wine rack with 220 grit sandpaper to prepare for finishing.

 

Step 7

Optionally, apply stain to enhance the appearance of the wine rack. Then, varnish it with polyurethane (like the Minwax Warm Satin or Clear Satin), applying at least two layers for protection.

After the first layer of varnish, sand the surface with 320-grit sandpaper for a smoother finish.

Final Thoughts

And that’s it! To be honest, I’m impressed with how this turned out, especially considering it’s made from construction-grade lumber. The key lies in being selective about your cuts, taking the time to get rid of any unsightly knot holes, and really cleaning up the surface before sanding it down to perfection. It's amazing what a difference these little steps can make in the final result.

If you're looking for an easier project, I also made a single wine rack that might be a good starting point. Hope you enjoyed this one!